R ™ • RS ™
REAR SUSPENSIONS
■ R • RS Cross Tube Selection Guides Key No. 2 Pages 507, 509, 511, 513, 517, 519, 521, 523
Cross Tubes
R | RS 40K • 46K • 48K
R | RS 52K
♦ R | ♦ RS 65K • 85K
♦ R | ♦ RS 100K • 120K
Length
Part Number 44643-027 44643-011 44643-008 44643-009 44643-003 44643-002 44643-001 44643-024 44643-015 44643-018 44643-017 44643-010 44643-028 44643-014 44643-029
Length
Part Number 07622-003 07622-018 07622-031 07622-014
Length
Part Number 10397-015 10397-018 10397-014 10397-019 10397-009 10397-001 10397-021 10397-017 10397-002 10397-010 10397-020 10397-027 10397-013 10397-003 10397-006 10397-025 10397-016 10397-008 10397-031 10397-004 10397-029
Length
Part Number 13504-004 13504-008 13504-002 13504-001 13504-009 13504-012 13504-006 13504-013 13504-005 13504-003 13504-011
33 7 ⁄
8 "
46" 53" 64" 68"
34¾"
44½"
40¾"
40"
46"
42"
40¾"
46¾"
44 7 ⁄
8 "
41"
49"
46" 47" 48"
41¾"
50¾"
42"
53"
42½" 43¼" 44¾"
54¾"
49¼"
56" 59"
51" 53"
46"
60¼" 62¼"
54½"
46½" 47½"
57" 64" 68" 77"
50"
51¼" 52¾"
54"
56½" 61¼" 62¾" 67½" 75¾"
♦ Corresponding Center Bushing End Plugs for Cross Tube Replacement 40K through 52K Only
Key Nos. 3, 6 Pages 507, 509, 517, 519
Rubber Center Bushing Part Number 49400-000L • 49600-000L
End Plug Part Number
Bronze Beam Center Sleeve Part Number
End Plug Part Number
Capacity
40K • 46K
22281-000
14685-000L
57263-000
40K • 46K • 48K • 52K 29483-005L • 34013-097L NOTE: ♦ Hendrickson recommends on higher capacity walking beam suspensions removal of the equalizing beam to replace the cross tube. Refer to Hendrickson publication No. 17730-190 for more information.
NOTES: * Not supplied by Hendrickson, used for reference only. Hendrickson is not responsible for components supplied by the vehicle manufacturer. For assistance with maintenance and rebuild instructions on these components see vehicle manufacturer. ** Item included in kit / assembly only, part not sold separately. *** Hendrickson’s part number is stamped on the torque rod for identification. Be sure to include the suffix number when ordering, this number indicates rod length. Hendrickson’s two-piece ULTRA ROD • ULTRA ROD PLUS can be used to create the desired length, refer to Torque Rod Selection Guide 45745-148. **** Transverse torque rods are mandatory for the R suspensions regardless of axle spacing, see Literature No. 59310-004 and 59310‑058 for more information. ***** Longitudinal and transverse TRAAX ROD bushings are non-serviceable, the entire torque rod assembly requires replacement. Visit TRAAX ROD website www.traaxrods.com for more information.
514
www.hendrickson-intl.com | Reference Lit. Nos. SP-166 & SP-167
Powered by FlippingBook