FIREMAAX ® EX
REAR SUSPENSIONS
Top Pad • Bottom Cap Selection Guide (continued) | Large Clamp Group 8½", 8 5 ⁄ 8 ", 8¾", 9", 12½" Ride Heights with Axle Spacer (below axle)
Bottom Cap Part Number Left / Right Side
Axle Spacer Part Number
Top Pad Part Number
Axle Series
Beam Spacing
Left Side
Right Side
Left Side
Right Side
Straight
Straight
Transition Straight
Transition Straight
Transition Straight
Transition
SINGLE AXLE
40 40.3
♦ 65208-001 ♦♦ 65208-101 ♦ 65208-001 ♦♦ 65208-101 ♦ 65208-002 ♦♦ 65208-102 ♦ 65208-001 ♦♦ 65208-101 ♦ 65208-001 ♦♦ 65208-101 ♦ 65208-002 ♦♦ 65208-102
65277-000 65276-000
65210-003 65210-001
Meritor 185
67973-012 67973-010
65273-010 65273-009
41
Dana 190
40 40.3
65275-000 65274-000
65210-004 65210-002
TANDEM FRONT
40 40.3
65276-000
65277-000 65210-001
65210-003
Meritor 185
67973-010
67973-012 65273-009
65273-010
41
Dana 190
40 40.3
65274-000
65275-000 65210-002
65210-004
TANDEM REAR
65210-003 Replaces 65210-103 65273-010 Replaces 65273-110 65210-004 Replaces 65210-104
65210-001 Replaces 65210-101 65273-009 Replaces 65273-109 65210-002 Replaces 65210-102
40 40.3
♦ 65208-003 ♦♦ 65208-103
65277-000 65276-000
Meritor 185
♦ 65208-003 ♦♦ 65208-103
41
67973-012 67973-010
Dana 190
40 40.3
♦ 65208-004 ♦♦ 65208-104
65275-000 65274-000
NOTE : ♦ Equipped with air disc brakes. ♦♦ Equipped with drum brakes.
Continued on next Page
NOTES: Quantities specified are shown for single suspension.Adjust quantities for tandem or tridem suspensions. Quantities of service kit components may vary from amount shown in the list. LONGITUDINAL torque rods and Transverse TRAAX ROD bushings are non-serviceable, the entire torque rod assembly requires replacement.Visit TRAAX ROD website www.traaxrods.com for more information. * Item included in kit / assembly only, part not sold separately. ** Transverse torque rods are mandatory for the FIREMAAX EX suspensions regardless of axle spacing, see Literature Nos. 59310‑004 and 59310-058 for more information. *** S-cam bracket is not required for the vehicles equipped with Air Disc Brakes. ♦ Alternate configuration of the QUIK-ALIGN fasteners.The locknuts located inboard will allow additional clearance for wider tires or tires with chains.Tightening is still required ONLY on the locknut.
357
Reference Lit. No. SP-337 | 855-743-3733
Powered by FlippingBook